Difference between revisions of "Wearables: First Steps"
Jump to navigation
Jump to search
| Line 26: | Line 26: | ||
[[File:01wb.png | 800px]] | [[File:01wb.png | 800px]] | ||
<br> | <br> | ||
| − | Cut conductive fabric that has fusible interfacing on one side. peel off the backing paper and place it on base fabric. Make sure the iron is set to synthetic. Most conductive fabric is delicate. And you do also rist the glue from the interfacing glue to appear of the front. | + | Cut conductive fabric that has fusible interfacing on one side. peel off the backing paper and place it on base fabric. Make sure the iron is set to synthetic. Most conductive fabric is delicate. And you do also rist the glue from the interfacing glue to appear of the front.<br> |
| − | [[File:02wb.png |800 px]] | + | |
| − | You can cut each side or fold to make corners. In both cases we need to check if all connections are right. We will use the continuity setting. | + | [[File:02wb.png |800 px]]<br> |
| − | [[File:03wb.png | 800 px]] | + | |
| + | You can cut each side or fold to make corners. In both cases we need to check if all connections are right. We will use the continuity setting.<br> | ||
| + | |||
| + | [[File:03wb.png | 800 px]]<br> | ||
| + | |||
==with button== | ==with button== | ||
Revision as of 07:55, 24 September 2018
Intro
This is an introduction to working with soft electronics.Combining and entwining circuits and fabrics. We will go trough the fundamental knowledge of electricity and how we can use it in various ways to make soft interfaces.
Materials
conductive
resistive
non-conductive
Tools
sewing machine
multimeter
pliers
scissors
lasercutter
vinyl cutter
breadboard
microcontroller
arduino
flora
Hello wolrd: Soft circuit
simple
Lets s start my making the hello world of soft and any kind of circuitry:)
Cut conductive fabric that has fusible interfacing on one side. peel off the backing paper and place it on base fabric. Make sure the iron is set to synthetic. Most conductive fabric is delicate. And you do also rist the glue from the interfacing glue to appear of the front.
You can cut each side or fold to make corners. In both cases we need to check if all connections are right. We will use the continuity setting.
