Tutorial: Surfacing the CNC bed

Surfacing the CNC bed

1. Installing the surfacing Mill

A. To surface the bed, you need the biggest 2 flute mill there is. The bigger the mill, the less time it will take to completely surface the bed. For this example we use a 6mm two flute mill. A 2 flute mill should look something like this:

B. Check if the collet is bit enough for the mill. You can assess this by looking at the thickness of the CNC mill. There are three sizes we use for the CNC mills, small, medium and big. For surfacing, we use the big one. If the collet is too small for the mill, unscrew the collet using two wrenches.

C. Now unscrew the nut in the collet using a hex key, install the mill, and screw it tight again.

2. Setting your X,Y,Z position

A. Open VPanel for SRM-20. Make sure the CNC is turned on and the lid is closed. Otherwise it the CNC does respond.

B. To properly surface the machine (or mill in general), we need the CNC to know where the face is it needs to mill. For surfacing we simply need to start at X = 0, and Y = 0, and set the right Z axis. To do this set the Machine Coordinate System of the top left to G54:

and move the Mill all the way to the bottom left using the arrows.

Now drop down the mill with the Z-arrows until almost touch the surface. !! Be careful not to hit the surface!! You will break the mill.

Make more precise adjustment by changing the Cursor step.

When you are as close as possible to the surface. Unscrew the mill with the small hex key, let it drop

and tighten it again.

Now set the new origin point to G54 and click X/Y and Z.

X, Y, Z should now be 0, 0, 0.

3. Uploading the G-Code using an existing .nc file.

This option is optimized for a 5mm or 6mm drill bit and will surface the bed with a 1mm depth. If you have a different mill or would like to surface it a bit deeper, follow the steps in 4.

A: Download Flatcam Surfacing .zip folder, unpack it.

File:FlatcamSurfacing.zip

B: Open VPanel for SRM-20.

C: Press Cut

and press Add

look for the file called "Schets_contour.gm1_cutout_1_paint_cnc.nc", open it.

D. Press "OUTPUT" to start the milling process.

4. Creating your own Surfacing G-Code.

If you would like to make sure precise adjustments to the surfacing, like changing the depth or the size of the milling bit, you can do it by using flatcam.

A. Open Flatcam and Open "flatcamsurfacing.FlatPrj" from your unpacked archive.

B. Changing the surface depth.

If you want to surface a bit deeper than 1mm, first delete the existing CNC job.

Then double click "Schets_contour.gm1_cutout_1_paint"

and change the CutZ to the preferred depth in mm (should always be negative!)