Write to Arduino No firmata

1. Send data from Touchdesigner

Firmata

Palette —> tools —> Firmata

2. Arduino received data

Firmata

file --> example --> Firmata --> StanderFirmata

Serial.read()

Arduino code

 1#define led01 12
 2#define led02 13
 3//constant from Touchdesigner
 4byte degreesTouchdesigner; //setpoint send by Touchdesigner
 5
 6void setup() {
 7  //start serial port at 9600 bps:
 8  Serial.begin(9600);
 9  while (!Serial)
10  {
11    ;// wait for serial port to connect. Needed for native USB port only.
12    }  
13  // Declare pins as output:
14  pinMode(led01, OUTPUT);
15  pinMode(led02, OUTPUT);
16}
17
18void loop() {
19  if(Serial.available() > 0)
20  {
21    degreesTouchdesigner = Serial.read(); // read the values from Touchdesigner
22    Serial.print(degreesTouchdesigner);
23    if (degreesTouchdesigner>120)
24    {
25      digitalWrite(led01,LOW);
26      digitalWrite(led02,HIGH);    
27       }   
28       else
29       {
30        digitalWrite(led02,LOW);
31      digitalWrite(led01,HIGH);
32       }    
33  }
34}

in TouchDesigner:

serial1 op

one per byte

CHOP Execute: select the CHOPS. Channels.

code:

# me - this DAT
# 
# channel - the Channel object which has changed
# sampleIndex - the index of the changed sample
# val - the numeric value of the changed sample
# prev - the previous sample value
# 
# Make sure the corresponding toggle is enabled in the CHOP Execute DAT.

def onOffToOn(channel, sampleIndex, val, prev):
	return

def whileOn(channel, sampleIndex, val, prev):
	return

def onOnToOff(channel, sampleIndex, val, prev):
	return

def whileOff(channel, sampleIndex, val, prev):
	return

def onValueChange(channel, sampleIndex, val, prev):
	op('serial1').sendBytes(val)
	return