Servo motor
Jump to navigation
Jump to search
Italic textOK, so your Ardiono blinks, that was Hello World!
Servo motor
Now we will hookup a servo motor and instruct it to behave a certain way.
This is a servo, a very small one
Hookup
The servo has 3 wires, we need to connect them all to the arduino.
red is for 5V
you will find it easy to plug one end of a jumper wire inside the connectors of the servo motor, and the other end to the corresponding pin of the Arduino make sure you use corresponding colors for the jumpers, in bigget setups messy wire can cause you more time to debug
black is for GND
to GND of the Arduino
and orange is for signal
signal is going into the pin of the Arduino we will use to control the servo motor